Driver Board Size: 55mm * 49mm * 33mm (with fixed copper pillar and the heat sink height).Maximum power consumption: 20W (when the temperature T = 75 ☌).Step 3) Deploy Arduino Sketch to read ESP8266 data from SoftwareSerial. High: 2.3V ≤ Vin ≤ Vss (control signal active) Step 2) Use Arduino to upload new sketch.Low: -0.3 ≤ Vin ≤ 1.5V (control signal is invalid).the operating current range of the logical part : 0 ~ 36mA.the terminal supply of area the logical part Vss: +5 V ~ +7 V (can take power within the board +5 V).The terminal supply area of driven part Vs: +5 V ~ +35 V such as the need to take power within the board, the supply area Vs: 7V ~ 35V.
#L298n motor driver board arduino sketch full#
This module is based on L298N,high voltage,high current dual full bridge driver which can be used to drive a DC motor and stepper motor, relay coil inductive load using standard logic level signal control having two enable control end allow or prohibit the work has a logic device power supply input terminal, in the case. Driver: L298N Dual H Bridge DC Motor Driver IC This module can drive either 2 DC motors or 1 Stepper motor at a time. This dual bidirectional motor driver is based on the very popular L298 Dual H, -Bridge Motor Driver Integrated Circuit.